Dell OptiPlex 9010 AIO - Installing the Camera

Installing the Camera
1. Tighten the screws to secure the camera to the chassis.
2. Connect the camera cable and fix the latch.
3. Install:
a) display panel
b) system board
c) power-supply fan
d) heat-sink assembly
e) power supply unit
f) processor fan
g) converter board
h) power-button board
i) intrusion switch
j) hard drive
k) optical drive
l) WLAN card
m) input/output board shield
n) system-board shield
o) VESA mount bracket
p) back cover
q) VESA stand
4. Follow the procedures in After Working Inside Your Computer .
36