Dell OptiPlex 9010 AIO - Installing the Processor Fan; Removing the Processor; Installing the Processor

Installing the Processor Fan
1. Place the processor fan on the computer and tighten the screws to secure the processor fan to the system board.
2. Connect the processor-fan cable to the connector on the system board.
3. Install:
a) system-board shield
b) VESA mount bracket
c) back cover
d) VESA stand
4. Follow the procedures in After Working Inside Your Computer .
Removing the Processor
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the:
a) VESA stand
b) back cover
c) VESA mount bracket
d) system-board shield
e) heat-sink assembly
3. Press the release lever down and then move it outward to release it from the retention hook that secures it. Lift the
processor cover and remove the processor from its socket.
Installing the Processor
1. Insert the processor into the processor socket. Ensure the processor is properly seated.
2. Press the release lever down and then move it inward to secure it with the retention hook.
3. Install:
a) heat-sink assembly
b) system-board shield
c) VESA mount bracket
d) back cover
e) VESA stand
4. Follow the procedures in After Working Inside Your Computer .
27