Dell OptiPlex 9030 - Installing the System-Board Shield; Removing the Converter Board

3. Perform the following steps as shown in the illustration:
a. Press the securing tab down to release the system-board shield from the slots on the chassis [1].
b. Slide the system-board shield and lift it away from the computer [2].
Installing the System-Board Shield
1. Align and place the system-board shield on the back of the computer.
2. Tighten the screws that secure the system-board shield to the computer.
3. Install the:
a. VESA mount bracket
b. back cover
c. VESA stand
4. Follow the procedures in After Working Inside Your Computer.
Removing the Converter Board
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the:
a. VESA stand
b. back cover
16