Removing the Display Panel
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the:
a. VESA stand
b. back cover
c. VESA mount bracket
d. system-board shield
e. input/output (I/O) board shield
f. WLAN card
g. optical drive
h. hard drive
i. intrusion switch
j. power and OSD buttons board
k. converter board
l. power-supply fan
m. power supply unit
n. heatsink assembly
o. processor fan
p. speakers
q. speaker cover
r. antenna module
s. system board
NOTE: These instructions are valid only for non-touch computers. For touch computers, the
display panel should be disassembled in a clean-room environment.
3. Perform the following steps as shown in the illustration:
a. Remove the screws that secure the release latch holders to the display-panel base [1] .
b. Lift the release latch holders off the display-panel base [2].
c. Remove the screws that secure the release latch brackets to the display-panel base [3].
d. Lift the release latch brackets off the display-panel base [4].
e. Rotate and lift the release latch lock brackets off the display-panel base [5].
37
To Next Page
Loading...
