Removing and Replacing Parts on the Midsize Chassis 5-9
'ULYHV
Figure 5-7 shows an example of drive hardware that can be installed in the
computer. Refer to this figure when you perform any of the procedures in the
following subsections.
)LJXUH'ULYH+DUGZDUH
([WHUQ DOO\$FFHVVLEOH 'ULYH$VVHPEOLH V
The following subsections contain removal/replacement procedures for drives
installed in the externally accessible drive bays.
diskette/tape drive
interface cable
DC power
cable
DSKT connector
system
power
supply
hard-disk drive bracket
secondary EIDE interface
connector (IDE2)
primary EIDE
interface
connector (IDE1)
EIDE cable
3.5-inch diskette
drive
To Next Page
Loading...
