Removing and Replacing Parts on the Mini Tower Chassis 6-21
onto its corresponding tab. Push evenly on both sides of the system board as
you slide it into position (do not twist the system board).
6\VWHP%RDUG&RPSRQHQWV
The subsections that follow Figure 6-20 contain procedures for removing/
replacing system board components.
)LJXUH6\VWHP%RDUG&RPSRQHQWV
SEC cartridge connector (SLOT1)
microprocessor fan
connector (FAN)
microphone jack (MIC)
video connector
(MONITOR)
serial port 2
connector (SERIAL2)
USB connectors (2)
(USB)
parallel/serial port 1
connectors (stacked)
(PARALLEL/SERIAL1)
keyboard/mouse
connectors (stacked)
(KYBD/MOUSE)
audio line-in
jack (LINE-IN)
audio line-out
jack (LINE-OUT)
video-memory
upgrade socket
(VIDEO_UPGRADE)
control panel
connector (PANEL)
battery socket
(BATTERY)
optional
integrated NIC
connector (ENET)
riser board connector (RISER)
system board jumpers
primary EIDE
interface connector
(IDE1)
secondary EIDE
interface connector
(IDE2)
front of computer
diskette/tape drive
interface connector
(DSKT)
DIMM sockets (3)
(DIMM_A–DIMM_C)
main power input
connector (POWER_1)
3.3-V power input
connector (POWER_2)
ATI multimedia
connector (AMC)
CD-ROM audio
interface connector (CD_IN)
telephony
connector
(TAPI)
chassis-intrusion switch
connector (INTRUSION)
To Next Page
Loading...
