Dell OptiPlex GX1 - Inch Drive Assembly

Removing and Replacing Parts on the Mini Tower Chassis 6-13
To remove a 5.25-inch drive assembly from the middle or lower drive bay, fol-
low these steps:
 'LVFRQQHFWWKH'&SRZHUFDEOHDQGWKHLQWHUIDFHFDEOHIURPWKH
EDFNRIWKHGULYH
 3UHVVLQRQWKHWZRUHWDLQLQJWDEVRQHRQHDFKVLGHRIWKHGULYH
DQGVOLGHWKHGULYHDVVHPEO\IRUZDUGWRUHPRYHLW
 5HPRYHWKHIRXUVFUHZVDWWDFKLQJWKHLQFKGULYHWRWKH
PRXQWLQJSODWHDQGOLIWWKHGULYHRXWRIWKHPRXQWLQJSODWHVHH
)LJXUH
)LJXUH,QFK'ULYH5HPRYDO
When you replace the 5.25-inch drive, align the front of the drive flush with the
tab at the front of the mounting plate. Insert the four screws, and tighten them
in the order stamped on the bottom of the 5.25-inch drive-mounting plate.
Align the front of the drive
flush with the tab at the
front of the 5.25-inch
drive-mounting plate.
screws (4)