Dell OptiPlex GX1 - Microprocessor

5-12
'HOO2SWL3OH[*;0DQDJHG3&DQG2SWL3OH[1;1HW3&6\VWHPV6HUYLFH0DQXDO
When you replace the 5.25-inch drive, align the front of the drive flush with the
tab at the front of the mounting plate. Insert the four screws, and tighten them
in the order stamped on the bottom of the 5.25-inch drive-mounting plate.
+DUG'LVN'ULYH%UDFNHW
)LJXUH+DUG'LVN'ULYH%UDFNHW5H PRYDO
To remove the hard-disk drive bracket, follow these steps:
 'LVFRQQHFWWKH'&SRZHUFDEOHDQGWKHLQWHUIDFHFDEOHIURPWKH
EDFNRIHDFKKDUGG LVNGULYHLQVWDOOHGLQWKHKDUGGLVNGULYH
EUDFNHW
 5HPRYHWKHVFUHZWKDWVHFXUHVWKHKDUGGLVNGULYHEUDFNHWWRWKH
IURQWRIWKHFKDVVLV
 *UDVSWKHKDQGOHRQWKHIURQWRIWKHEUDFNHWDQGURWDWHWKHIURQW
RIWKHEUDFNHWXSXQWLOWKHKRRNVDUHIUHHIURPWKHFKDVVLV
 /LIWWKHKDUGGLVNGULYHEUDFNHWRXWRIWKHFRPSXWHU
When you reinstall the hard-disk drive bracket, place the lower-back tab of the
hard-disk drive bracket into position (be sure that the opening in the lower-back
tab is over the alignment tab on the chassis); then rotate the front of the
bracket down into position.
handle
screw
lower-back tab
hard-disk drive
bracket