Dell OptiPlex GX1 - Page 166

A-4
'HOO2SWL3OH[*;0DQDJHG3&DQG2SWL3OH[1;1HW3&6\VWHPV6HUYLFH0DQXDO
7DEOH$6\VWHP6HWXS&DWHJRULHV
&DWHJRU\ )XQFWLRQ
Time Resets time on computer’s internal clock.
Date Resets date on computer’s internal calendar.
Diskette Drive A
Diskette Drive B
Identifies type of diskette drives installed. Cat-
egory options always match physical locations
of drives in computer. Tape drives are
not
reflected in these categories.
NOTE: For OptiPlex NX1 chassis, a single dis-
kette drive can be used for service purposes
only.
Drives:
Primary
Secondary
Identifies drives attached to the IDE1 and IDE2
connectors on system board. Each EIDE con-
nector supports two EIDE drives (Drive 0 and
Drive 1).
For EIDE hard-disk drives, the system provides
an automatic drive-type detect feature. To use
this feature, highlight the appropriate Drive
category and type a (for
automatic
).
If none of the supported drive types matches
the parameters of the new drive, enter
parameters directly. To do so, highlight the
appropriate Drive category (Drive 0 or Drive 1)
and type u to display 8VHU. Press
<
Tab
>
to
highlight each of the parameter fields in suc-
cession, and enter the appropriate number for
each field.
NOTES: For EIDE devices such as EIDE
CD-ROM drives and EIDE tape drives that are
using the built-in EIDE controller, set the
appropriate Drive category to Auto.
OptiPlex NX1 chassis supports only one hard-
disk drive and no CD-ROM drive or tape drive.
Reserved Memory Designates a region of system board memory
that can be supplied by an expansion card.
This feature should not be enabled unless an
expansion card that requires special address-
ing is installed.
CPU Speed Indicates processor speed at which system
boots—the processor’s rated speed or a
slower compatibility speed, which disables
cache.
Num Lock Determines whether keyboard’s Num Lock
mode is activated.