Dell OptiPlex GX1 - Page 168

A-6
'HOO2SWL3OH[*;0DQDJHG3&DQG2SWL3OH[1;1HW3&6\VWHPV6HUYLFH0DQXDO
Wakeup On LAN Wakeup On LAN determines whether the
Wakeup On LAN feature is set to Off or On.
You must reboot your system before a change
takes effect.
Sound Enables (On) or disables (Off) the integrated
sound controller.
NIC Enables (On) or enables without PXE support
(On [PXE Off]) or disables (Off) the integrated
NIC.
Mouse Enables or disables the built-in PS/2-
compatible mouse port.
Serial Port 1 Configures system’s built-in serial port 1.
Serial Port 2 Configures system’s built-in serial port 2.
Parallel Port Configures system’s built-in parallel port.
The port’s I/O address may be set to 278h
,
3BCh, or 378h
.
Otherwise, the port may be
disabled.
Parallel Mode Controls whether system’s built-in parallel port
acts as an AT-compatible (unidirectional) or
PS/2-compatible (bidirectional) port.
IDE Hard Disk Enables system’s built-in EIDE hard-disk drive
interface.
Diskette Enables system’s built-in diskette drive
controller.
Speaker Enables on-board speaker.
Microprocessor Displays type of microprocessor installed.
Level 2 Cache Displays size of level-2 cache memory
installed.
System Memory Displays entire amount of installed memory
detected in system, except for memory on
EMS expansion cards.
Video Memory Displays amount of video memory on the sys-
tem board.
Service Tag Displays system’s five-character service tag
number.
Asset Tag Displays the asset tag number up to ten char-
acters if one is assigned.
7DEOH$6\VWHP6HWXS&DWHJRULHVFRQWLQXHG
&DWHJRU\ )XQFWLRQ