Dell OptiPlex GX1 - Page 77

Removing and Replacing Parts on the Low-Profile Chassis 4-5
 7RUHPRYHWKHSRZHUEXWWRQRUWKHUHVHWEXWWRQXVHDVPDOO
VFUHZGULYHUDQGSXVKLQRQWKHWZRRUWKUHHSODVWLFFOLSVWKDWKROG
WKHEX WWRQ  WR WK H  FRPSXWHU FRYHU
When these clips are released, the button comes free from the front panel
of the cover.
)URQW3DQHO,QVHUWV
)LJXUH)URQW3DQHO,QVHUW5HPRYDO
To remove a front-panel insert, follow these steps:
 /D\WKHFRPSXWHUFRYHUXSVLGHGRZQRQDIODWZRUNVXUIDFHZLWK
WKHIURQWRIWKHFRYHUIDFLQJ\RX
 )URPWKHIURQWRIWKHFRYHUXVH\RXUWKXPEVWRSXVKLQZDUGRQ
WKHLQVHUWXQWLOLWVOLGHVRIIWKHWZRSRVWV
To replace a 5.25-inch front-panel insert, position the two ring-tabs over the
posts on the inside of the bay opening, and then press the ring-tabs over the
posts. If necessary, use a
1/4
-inch nutdriver to help push on the ring-tabs.
ring-tabs (2)
posts (2)
computer cover
(upside down)
5.25-inch
front-panel
insert