Removing and Replacing Parts on the Low-Profile Chassis 4-7
'ULYHV
Figure 4-6 shows an example of drive hardware that can be installed in the
computer. Refer to this figure when you perform any of the procedures in the
following subsections.
)LJXUH'ULYH +DUGZDUH
([WHUQ DOO\$FFHVVLEOH 'ULYH$VVHPEOLH V
The following subsections contain removal/replacement procedures for drives
installed in the externally accessible drive bays.
EDFN
power supply
diskette/tape drive
interface cable
DC power cable
hard-disk drive
3.5-inch diskette drive
EIDE cable
DSKT connector
primary EIDE
interface
connector (IDE1)
secondary EIDE
interface
connector (IDE2)
5.25-inch drive
bay and bracket
To Next Page
Loading...
