Dell OptiPlex GX1 - Page 87

Removing and Replacing Parts on the Low-Profile Chassis 4-15
6\VWHP%RDUG
)LJXUH6\VWHP%RDUG5HPRYDO
To remove the system board, follow these steps:
 'LVFRQQHFWDOOFDEOHVIURPWKHLUFRQQHFWRUVDWWKHEDFNRIWKH
FRPSXWHU
 5HPRYHWKHH[SDQVLRQFDUGFDJH
 'LVFRQQHFWDOOFDEOHVIURPWKHV\VWHPERDUG
 5HPRYHWKHVFUHZWKDWVHFXUHVWKHV\VWHPERDUGWRWKHERWWRPRI
WKHFKDVVLV
 6OLGHWKHV\VWHPERDUGWRZDUGWKHIURQWRIWKHFKDVVLVXQWLOLW
VWRSV
 &DUHIXOO\OLIWWKHV\VWHPERDUGRXWRIWKHFKDVVLVEHVXUHWROLIW
HYHQO\DQGQRWWZLVWWKHV\VWHPERDUG
NOTES: If you are replacing the system board, remove all DIMMs, the
video-memory upgrade module (if present), the single-edge contact (SEC)
cartridge/heat sink assembly, and the guide bracket assembly from the old sys-
tem board and install them on the replacement board. Also, set the jumpers on
the new system board so that they are identical to those on the old board,
unless a microprocessor upgrade is being installed.
If the original system board has a NIC connector, ensure that the replacement
board has a NIC connector.
screw
slots (5)
tabs (5)