Steps
1. Align the notch on the M.2230 solid-state drive with the tab on the M.2 card slot on the system board.
2. Slide the M.2230 solid-state drive into the M.2 card slot on the system board.
3. Replace the screw (M2x3.5) that secures the M.2230 solid-state drive to the system board.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
Solid-state drive (full-length)
Removing the M.2280 solid-state drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
About this task
The following images indicate the location of the M.2280 solid-state drive and provides a visual representation of the removal
procedure.
Removing and installing Customer Replaceable Units (CRUs)
53
To Next Page
Loading...
