Steps
1. Insert the intrusion switch into its slot and slide the switch to secure it into the slot.
2. Route the intruder cable through the retention clip.
3. Connect the intruder cable to the connector on the system board.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
Power-supply unit
Removing the power-supply unit
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
About this task
The following images indicate the location of the power-supply unit and provides a visual representation of the removal
procedure.
66
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
