Steps
1. Using a screwdriver, remove the serial module cover from the chassis.
NOTE: This step is applicable only when the serial module is being installed for the first time.
2. Connect the serial-module cable to the connector (KB_MS_SERIAL) on the system board
3. Insert the serial module into the slot on the chassis.
4. Replace the two (4-40x6.5) screws that secure the serial module to the chassis.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
VGA module
Removing optional VGA module
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
Removing and installing Field Replaceable Units (FRUs)
87
To Next Page
Loading...
