About this task
The following images indicate the location of the optional DisplayPort module and provide a visual representation of the removal
procedure.
Steps
1. Remove the two (M3X3) screws that secure the optional DisplayPort module to the computer chassis.
2. Disconnect the DisplayPort module cable from the connector on the system board.
3. Remove the DisplayPort module from the computer.
Installing optional DisplayPort module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the optional DisplayPort module and provide a visual representation of the
installation procedure.
90
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
