Place the palm-rest and keyboard assembly on a flat and clean surface and perform the post-requisites to install the palm-rest
and keyboard assembly.
Next steps
1. Install the system board.
2. Install the power button.
3. Install the power-adapter port.
4. Install the plastic display assembly or aluminum display assembly (whichever applicable).
5. Install the touchpad.
6. Install the speakers.
7. Install the I/O board.
8. Install the I/O board FFC.
9. Install the UMA heat sink or discrete heat sink (whichever applicable).
10. Install the fan.
11. Install the wireless card.
12. Install the M.2 2230 solid state drive or M.2 2280 solid state drive (whichever applicable).
13. Install the memory modules.
14. Install the 3-cell battery or 4-cell battery (whichever applicable).
15. Install the base cover.
16. Install the SD card.
17. Follow the procedure in After working inside your computer.
140
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
