Removing the solid-state drive
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
CAUTION: To avoid data loss, do not remove the solid-state drive while the computer is in sleep or on state.
Topics:
• Prerequisites
• Procedure
Prerequisites
Remove the base cover.
Procedure
1. Locate the solid-state drive on the system board.
2. Remove the screw (M2x3) that secures the solid-state drive to the I/O board.
3. Lift and slide the solid-state drive to remove it from the solid-state drive slot on the system board.
15
28 Removing the solid-state drive
To Next Page
Loading...
