Removing the display assembly
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Prerequisites
• Procedure
Prerequisites
1. Remove the base cover.
2. Remove the wireless card.
Procedure
1. Remove the four screws (M2.5x4) that secure the left and right hinges to the system board and I/O board.
2. Note the routing of the antenna cables and remove the cables from the routing guides on the fan.
3. Disconnect the display cable from the system board.
4. Lift the palm-rest and keyboard assembly at an angle.
25
Removing the display assembly 41
To Next Page
Loading...
