Steps
1. Locate the power button slot on your computer.
2. Align and place the power button into the slot on your computer.
3. Replace the two (M2x2) screws and the two (M2x3) screws to secure the power button to the palmrest assembly.
4. Adhere the adhesive tape above the power button.
5. Connect the power button cable to the connector on the system board and close the latch.
6. Close the right display hinge and replace the three (M2.5x5) screws to secure the right display hinge to the palmrest
assembly.
Next steps
1. Install the Input and output board.
2. Install the system fan.
3. Install the battery.
4. Install the base cover.
5. Follow the procedure in After working inside your computer.
Power button with fingerprint reader
Removing the power button with fingerprint reader
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the system fan.
5. Remove the input and output board.
About this task
The figure indicates the location of the power button with fingerprint reader and provides a visual representation of the removal
procedure.
Removing and installing components
53
To Next Page
Loading...
Need help?
General
