Dell POWERCONNECT 5524 - Manual Assignment

To Next Page

To Previous Page

Stacking

Manual Assignment

To assign unit IDs to the switches in the stack, do the following for each

switch in the stack:

Connect the switch to the terminal, as described in "Connecting the

Switch to the Terminal".

Turn on the switch to begin auto boot and press

Return

Esc

to abort and

enter the

Start Up

menu.

Select

Stack menu

to open the

Stack Menu

Select

Set unit stack id

Enter either a Unit ID or 0. 0 indicates that the

unit ID will be assigned automatically.

NOTE:

The entire stack should be installed, as shown in Figure 2-1, before powering

up the switches.

For more information on stacking, see the Dell PowerConnect 5500 Series User

Guide on the Documentation CD.

Startup Menu

[1]Download Software

[2]Erase Flash File

[3]Password Recovery Procedure

[4]Set Terminal Baud-Rate

[5]Stack menu

[6]Back

[1]Show unit stack id

[2]Set unit stack id

[3]Back

ContaxGS.book Page 12 Friday, August 20, 2010 1:53 PM

Other manuals for Dell POWERCONNECT 5524