System Configuration 11
2
System Configuration
This section provides configuration scenarios for the following features:
•"Traceroute" on page11
• "Configuration Scripting" on page 13
• "Outbound Telnet" on page 16
• "Simple Network Time Protocol (SNTP)" on page 17
• "Syslog" on page 19
• "Port Description" on page 21
• "Storm Control" on page 22
• "Cable Test for Copper Ports" on page 23
NOTE: For information on setting up the hardware and serial or TFTP connection, refer to the
Getting Started
Guide
for your system.
Traceroute
Use Traceroute to discover the routes that packets take when traveling on a hop-by-hop basis to their
destination through the network.
• Maps network routes by sending packets with small Time-to-Live (TTL) values and watches the
ICMP time-out announcements
• Command displays all L3 devices
• Can be used to detect issues on the network
•Tracks up to 20 hops
• Default UDP port uses 33434 unless modified in the traceroute command
To Next Page
Loading...
