Switching Configuration 45
NOTE: A Trap identified by "operationalModeChangeTrap" is issued when the SNMP user changes the operational
mode.
If the new mode is selected from the Dell Setup wizard, or if a mode selected from the CLI/Web/SNMP
user interfaces, the mode is effective only after the next reload.
Overview
• Port Aggregator is simple to configure. If internal port(s) are mapped to multiple external ports for
bandwidth/high availability, these external ports will automatically be configured as an LACP trunk
group (if the Aggregator Group is configured to enable LACP automatically). All connectivity mapping
is done through a simplified user interface. This functionality is supported across stacked switches as
well, where all ports in the stack will be shown in a single interface and can be configured.
• Port Aggregator is completely interoperable. Dynamic (via LACP) and static LAGs are supported.
Figure 3-3 illustrates the default condition on a standalone M6220(not in a stack) with Port Aggregator
enabled.
To Next Page
Loading...
