54 Switching Configuration
console#show port-aggregator port summary 2
Group Member Ports Active Configured Current
Member Ports LACP Mode LACP Mode
----- ------------ ------------ ---------- ---------
2 1/g2,1/g6,1/g10 1/g2,1/g6,1/g10 static auto
1/g14,1/g18 1/g14,1/g18
console#show port-aggregator port summary
Gid Member Ports Active Configured Current
Member Ports LACP Mode LACP Mode
----- ---------------------- ---------- --------- ---------
1 1/g2-1/g16,1/g18-1/g20 Dynamic Dynamic
2 1/g1,1/g17,2/g1-2/g16 1/g17,2/g4 Dynamic Dynamic
2/g18-2/g20
3 Not configured Dynamic Dynamic
4 Not configured Dynamic Dynamic
Simple Switch Mode Supported CLI Commands
The following commands that were available in Interface mode of Normal switch mode are now available in
Simple mode and are allowed to execute on a Port Aggregator group. For example, to apply any of the
following commands on an aggregator group1, you should see at the prompt:
console(config-
aggregator-1)#
These are existing commands that are documented in the
CLI Command Reference
for your
PowerConnect switch.
vlan add vlan-list
vlan remove vlan-list
The following commands that are available in Normal switch mode are also available in Simple mode:
• AAA commands:
aaa authentication enable
aaa authentication login
enable authentication
To Next Page
Loading...
Need help?
General