Switching Configuration 53
----- ---------------- ------ -------------
2 4 Static Required
3 2 Static Required
1000 2 Static Required
1001 3 Static Required
Example #14: Show Group Configuration Summary
Use the show port-aggregator group summary [< GroupId >] command to show the parameters
configured on the aggregator group.
<Group Id>
is an optional parameter in the command and, if not
specified, the command shows all the configured parameters for all the Groups.
console#show port-aggregator group summary 2
Group VLANs Uplinks MTU Negotiation Speed Duplex
----- ----- ------- ------- ----------- ------- -------
2 4023 1 Default Default Default Default
console#show port-aggregator group summary
Gid VLANs Minimum MTU Negotiation Speed Duplex
Uplinks
--- ----- ------- ------- ----------- ------- -------
1 4022 1 Disabled Default Default Default
2 4023 1 Disabled Default Default Default
3 4024 1 Disabled Default Default Default
4 4025 1 Disabled Default Default Default
Example #15: Show Port Summary
Use the show port-aggregator [group < GroupId >] command to show the member ports in the
aggregator group.
<Group Id>
is an optional parameter in the command and, if not specified, the
command shows all the Groups and member ports.
To Next Page
Loading...
