Dell PowerConnect M6220 - Page 52

52 Switching Configuration
uplink ports should be active; otherwise, all the internal ports in the Group will be brought down. By
default, the minimum active uplinks for a Group is 1, which means at least one uplink port should be
active for the Aggregator Group to be active.
console(config)#port-aggregator group 2
console(config-aggregator-2)#minimum active uplinks 2
console(config-aggregator-2)#
Example #12: Show Group MAC Address Table
Use the show bridge address-table [port-aggregator group < GroupId >] command to show the MAC
address table for a particular aggregator group.
[port-aggregator group <Group Id> is an optional
parameter in the command and, if not specified, shows all the MAC entries in all the Groups.
console#show bridge address-table port-aggregator group 2
Aggregator Group: 2
Aging time is 300 Sec
VLAN MAC Address Port Type
----- ---------------- ------ --------------------
3 0006.2932.814D 1/g2 Static
1001 0006.2932.814B 1/g17 Static
Example #13: Show Group VLAN Table
Use the show vlan [port-aggregator group < GroupId >] command to show the VLAN table for a
particular aggregator group.
[port-aggregator group <Group Id> is an optional parameter in the
command and, if not specified, shows all the MAC entries in all the Groups.
console#show vlan port-aggregator group 2
Aggregator Group: 2
VLAN AggregatorGroup Type Authorization
----- ---------------- ------ -------------
3 2 Static Required
1000 2 Static Required
console#show vlan
VLAN AggregatorGroup Type Authorization