36 Switching Configuration
console(config-if-1/g2)#exit
console(config)#interface ethernet 1/g3
console(config-if-1/g3)#channel-group 1 mode auto
console(config-if-1/g3)#exit
console(config)#interface ethernet 1/g8
console(config-if-1/g8)#channel-group 2 mode auto
console(config-if-1/g8)#exit
console(config)#interface ethernet 1/g9
console(config-if-1/g9)#channel-group 2 mode auto
console(config-if-1/g9)#exit
console(config)#exit
Example 3: Show the Port Channels
By default, the system enables link trap notification
console#show interfaces port-channel
Channel Ports Hash Algorithm Type
------- ----------------------------- -------------------
ch1 Inactive: 1/g2, 1/g3 3
ch2 Inactive: 1/g8, 1/g9 3
ch3 No Configured Ports 3
ch4 No Configured Ports 3
ch5 No Configured Ports 3
ch6 No Configured Ports 3
--More-- or (q)uit
At this point, the LAGs could be added to the default management VLAN.
Web Interface Configuration: LAGs/Port-channels
To perform the same configuration using the Graphical User Interface, click Switching > Link
Aggregation > LAG Membership in the navigation tree.
To Next Page
Loading...
