Routing Configuration 61
4
Routing Configuration
This section describes configuration scenarios and instructions for the following routing features:
• "VLAN Routing" on page 61
• "Virtual Router Redundancy Protocol" on page 64
• "Proxy Address Resolution Protocol (ARP)" on page 66
•"OSPF" on page67
• "Routing Information Protocol" on page 77
• "Route Preferences" on page 80
• "Loopback Interfaces" on page 83
VLAN Routing
This section provides an example of how to configure PowerConnect 6200 Series software to support
VLAN routing.
NOTE: The management VLAN cannot be configured as a routing interface. The switch may also be managed
via VLAN routing interfaces.
CLI Examples
The diagram in this section shows a Layer 3 switch configured for VLAN routing. It connects two
VLANs, with two ports participating in one VLAN, and one port in the other. The script shows the
commands you would use to configure PowerConnect 6200 Series software to provide the VLAN
routing support shown in the diagram.
To Next Page
Loading...
