Jumpers and Connectors 145
8
Open the system. See "Opening and Closing the System" on page 54.
9
Install the jumper plug on the password jumper.
10
Lower the memory module shroud.
11
Close the system.
12
Reconnect your system and peripherals to their electrical outlets, and turn on the system.
13
Assign a new system and/or setup password.
To assign a new password using the System Setup program, see "Assigning a System Password" on
page 45.
Book.book Page 145 Friday, February 3, 2006 11:09 AM
To Next Page
Loading...
