Dell PowerEdge 2950 - Entering the BMC Setup Module; BMC Setup Module Options

Using the System Setup Program 49
Entering the BMC Setup Module
1 Turn on or restart your system.
2 Press < Ctrl-E > when prompted after POST.
If your operating system begins to load before you press <
Crtl-E >, allow the system to finish
booting, and then restart your system and try again.
BMC Setup Module Options
For information about the BMC Setup Module options and how to configure the emergency management
port (EMP), see the
BMC User’s Guide .
Book.book Page 49 Friday, February 3, 2006 11:09 AM