Dell PowerEdge C6100 - Page 103

Installing System Components 103
Figure 3-29. Removing and Installing the Mid-Plane Holder
14 Remove the screws that secure the lower midplane to the chassis.
Figure 3-30.
15 Disconnect all the cables from the lower midplane. See Figure 5-9.
Note the routing of the cable underneath the tabs on the chassis as you
remove them from the system. You must route these cables properly when
you replace them to prevent the cables from being pinched or crimped.
16 Lift the lower midplane out of the chassis. See Figure 3-30.
1 screw (8) 2 mid-plane holder
1
2
book.book Page 103 Thursday, March 4, 2010 4:38 PM