Dell PowerEdge EMT User Manual

About Your System 25
SATA port A/B/C/D
hard disk drive
failure
SATA port A/B/C/D
hard disk drive
auto-sensing error
Faulty drive. INT13 call
failure from the drive.
Ensure that the hard drive
cables are properly
connected. See
"Troubleshooting a Hard
Drive" on page 124.
SATA Port A/B/C/D
hard disk not found
SATA Port A/B/C/D set as
Auto, no disk installed.
Run the System Setup
program to correct the
settings. See "Using the
System Setup Program" on
page 29.
Sector not found
Seek error
Seek operation
failed
Faulty diskette or hard
drive.
See "Troubleshooting a
USB Device" on page 110
or "Troubleshooting a Hard
Drive" on page 124 for the
appropriate drive installed
in your system.
Shutdown failure Shutdown test failure. Ensure that all memory
modules are properly
installed. See
"Troubleshooting System
Memory" on page 118. If
the problem persists, see
"Getting Help" on
page 141.
The amount of
system memory has
changed.
Faulty memory module.
Information only, if you
have changed the memory
configuration.
See "Troubleshooting
System Memory" on
page 118. If the problem
persists, see "Getting Help"
on page 141.
Faulty memory module. See "Troubleshooting
System Memory" on
page 118. If the problem
persists, see "Getting Help"
on page 141.
Table 1-6. System Messages (continued)
Message Causes Corrective Actions
book.book Page 25 Wednesday, June 24, 2009 8:21 AM

Dell PowerEdge EMT Specifications

General

Brand	Dell
Model	PowerEdge EMT
Category	Server
Language	English