Dell PowerEdge FX2 - Table of Contents

3 PowerEdge FX2 - Upgrading from 10GbE Pass-through Modules to FN410S I/O Modules | version 1.0
Table of contents
Revisions............................................................................................................................................................................. 2
1 Introduction ................................................................................................................................................................... 4
1.1 Typographical conventions ................................................................................................................................. 4
1.2 Before upgrading ................................................................................................................................................ 4
2 Hardware ...................................................................................................................................................................... 5
2.1 The Dell PowerEdge FX2/FX2s and supported modules ................................................................................... 5
2.2 Dell 10GbE Pass-through Module ...................................................................................................................... 7
2.3 PowerEdge FN410S I/O Module ........................................................................................................................ 7
3 Upgrade ........................................................................................................................................................................ 8
3.1 Overview ............................................................................................................................................................. 8
3.2 Step-by-step example ......................................................................................................................................... 9
3.2.1 Part 1 - Configure the ToR switch .................................................................................................................... 11
3.2.2 Part 2 – Replace the PTM in Slot A1 with an FN410S ..................................................................................... 12
3.2.3 Part 3 – Replace the PTM in Slot A2 with an FN410S ..................................................................................... 14
A References and additional resources ......................................................................................................................... 16
B Components used in this guide .................................................................................................................................. 17
C Terminology ................................................................................................................................................................ 18
D FN IOM internal port mapping .................................................................................................................................... 19
D.1 Quarter-width servers with dual-port CNAs ...................................................................................................... 19
D.2 Half-width servers with dual-port CNAs ............................................................................................................ 20
D.3 Half-width servers with quad-port CNAs........................................................................................................... 21
D.4 Full-width servers with dual-port CNAs ............................................................................................................ 22
D.5 Full-width Servers with quad-port CNAs........................................................................................................... 23
E Support and feedback ................................................................................................................................................ 24