Steps
1. Press the release button to open the hard drive or SSD carrier handle.
2. Slide the hard drive or SSD carrier into the drive bay. Carefully align the channel on the hard drive or
SSD carrier with the appropriate drive slot on the blade.
3. Push the drive carrier into the slot until the handle makes contact with the blade.
4. Rotate the carrier handle to the closed position while pushing the carrier into the slot until it locks
into place.
The status LED indicator displays a steady green light if the drive is installed correctly. The drive
carrier LED green indicator flashes as the drive rebuilds.
Figure 42. Installing a hard drive
1. release button 2. hard drive(on backplane)
3. hard drive 4. hard drive carrier handle
Figure 43. Installing an SSD
1. release button 2. SSD
3. SSD carrier handle
110
To Next Page
Loading...
