Dell PowerEdge M830 - Idrac Direct LED Indicator Codes

Drive-status indicator pattern Condition
NOTE: The drive status indicator remains off until
all hard drives are initialized after the system is
turned on. Drives are not ready for insertion or
removal during this time.
Flashes green, amber, and turns off Predicted drive failure
Flashes amber four times per second Drive failed
Steady green Drive online
Flashes green for three seconds, amber for
three seconds, and turns off after six seconds
Rebuild aborted
iDRAC Direct LED indicator codes
NOTE: The iDRAC Direct LED indicator does not turn on when the USB port is used in the USB
mode.
Figure 5. iDRAC Direct LED indicator
1. iDRAC Direct status indicator
The iDRAC Direct LED indicator table describes iDRAC Direct activity when configuring iDRAC Direct by
using the management port (USB XML Import).
Table 4. iDRAC Direct LED indicator
Convention iDRAC Direct
LED indicator
Condition
A Green Turns green for a minimum of two seconds to indicate the start and
end of a file transfer.
B Flashing green Indicates file transfer or any operation tasks.
C Green and turns
off
Indicates that the file transfer is complete.
13