Dell PowerEdge M830 - Processor Blank and DIMM Blank

Figure 30. Installing the NDC
1. slot on the NDC 2. screw (2)
3. NDC 4. standoff (2)
5. connector 6. tab projections
Next steps
1. Install the mezzanine card.
2. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Removing the NDC
Installing a mezzanine card
Installing the system cover
Installing a blade
After working inside your system
Processor blank and DIMM blank
The processor blank and DIMM blank supplied with your system aids in directing airflow over the unused
processor sockets and DIMM slots.
CAUTION: If you are permanently removing a processor, you must install a socket protective cap
and a processor blank and DIMM blank in the vacant socket to ensure proper system cooling. The
processor blank and DIMM blank covers the vacant sockets for the DIMMs and the processor.
95