Dell PowerEdge M830 - Environmental Specifications

Video specifications
The PowerEdge M830 system supports Matrox G200 VGA controller integrated with iDRAC and 2 GB
video memory is shared with iDRAC application memory.
Environmental specifications
NOTE: For additional information about environmental measurements for specific system
configurations, see Dell.com/environmental_datasheets.
Table 9. Temperature specifications
Temperature Specifications
Storage –40°C to 65°C (–40°F to 149°F)
Continuous operation (for altitude less
than 950 m or 3117 ft)
10°C to 35°C (50°F to 95°F) with no direct sunlight on the
equipment
Fresh air For information about fresh air, see the Expanded Operating
Temperature section.
Maximum temperature gradient
(operating and storage)
20°C/h (36°F/h)
Table 10. Relative humidity specifications
Relative humidity Specifications
Storage 5% to 95% RH with 33°C (91°F) maximum dew point.
Atmosphere must be non-condensing at all times.
Operating 10% to 80% RH with 29°C (84.2°F) maximum dew point.
Table 11. Maximum vibration specifications
Maximum vibration Specifications
Operating 0.26 G
rms
at 5 Hz to 350 Hz (all operation orientations)
Storage 1.88 G
rms
at 10 Hz to 500 Hz for 15 minutes (all six sides
tested)
Table 12. Maximum shock pulse specifications
Maximum shock pulse Specifications
Operating Six consecutively executed shock pulses in the positive and
negative x, y, and z axes of 40 G for up to 2.3 ms.
Storage Six consecutively executed shock pulses in the positive and
negative x, y, and z axes (one pulse on each side of the
system) of 71 G for up to 2 ms.
20