1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the #1 Phillips screwdriver ready.
4. Remove the hard-drive or SSD cage.
NOTE: alignment pin (2) You must remove the hard-drive or SSD cage to replace a faulty hard-
drive or SSD cage or service other components inside the system.
Steps
1. Align the screw holes on the hard-drive or SSD cage with the screw holes on the chassis.
2. Lower the hard-drive or SSD cage into the chassis until it is seated firmly in place.
3. Install the five screws to secure the hard-drive or SSD cage to the chassis.
Figure 53. Installing a hard-drive or SSD cage
1. hard-drive or SSD cage 2. screw (5)
3. guide pin (5) 4. screw hole on the chassis (4)
5. standoff (2)
Next steps
1. Install the hard-drive or SSD backplane.
2. Install the hard drives or SSDs.
3. Follow the procedure listed in the After working inside your system section.
120
To Next Page
Loading...
