Figure 54. Removing a 2.5-inch (x4) SAS hard-drive or SSD backplane
1. hard-drive or SSD backplane 2. release latch (2)
3. guide pin (5) 4. retention screw on the hard-drive or
SSD backplane cable connector
5. connector 6. hard-drive or SSD backplane cable
Next steps
1. Install the hard-drive or SSD backplane.
2. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Installing a 2.5-inch (x4) SAS hard-drive or SSD backplane
Removing the blade
Removing the system cover
After working inside your system
123
To Next Page
Loading...
