Dell PowerEdge M830 - Page 132

Figure 59. Installing a 2.5-inch (x2) SATA hard drive or SSD plus 2.5-inch (x2) PCIe SSD backplane
1. hard-drive or SSD backplane 2. release latch (2)
3. guide pin (5) 4. connector on the system board
(SATA_BP)
5. hard-drive or SSD backplane cable
connector
6. connector on the system board
(J_PERC)
7. PCIe SSD backplane cable connector 8. PCIe SSD backplane cable
9. hard-drive or SSD backplane cable
Next steps
1. Install the hard drives or SSDs in their original locations.
2. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Removing a 2.5-inch (x2) SATA hard drive or SSD plus 2.5-inch (x2) PCIe SSD backplane
Installing the system cover
Installing a blade
After working inside your system
132