Figure 60. Removing a 1.8-inch (x12) SAS SSD backplane
1. SSD backplane 2. release latch (2)
3. guide pin (6) 4. backplane cable (2)
5. backplane cable connector that connects
to the connector on the system board
6. connector on the system board
(SATA_BP)
7. connector on the expander card (EXP) 8. backplane cable connector that
connects to the connector on the
expander card
Next steps
1. Install the SSD backplane.
Related Links
Safety instructions
Before working inside your system
Installing a 1.8-inch (x12) SAS SSD backplane
Removing the blade
Removing the system cover
After working inside your system
134
To Next Page
Loading...
