Installing System Components 117
5
Slide out the expansion-card latch and remove the filler bracket. See
Figure 3-16.
6
Holding the card by its edges, position the card so that the card-edge
connector aligns with the expansion-card connector.
7
Insert the card-edge connector firmly into the expansion-card connector
until the card is fully seated.
8
Slide the expansion-card latch into position. See Figure 3-16.
Figure 3-16. Installing and Removing an Expansion Card
9
Connect the cables to the expansion card.
1 expansion-card latch 2 expansion card
3 expansion-card connector
book.book Page 117 Thursday, February 18, 2010 2:06 PM
To Next Page
Loading...
