Installing System Components 133
1
Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2
Open the system. See "Opening the System" on page 84.
3
Position the module so the tabs on the underside of the tray fit into the
hooks on the front-chassis assembly, then lower the opposite edge of the
card into place. See Figure 3-22.
4
Connect the internal dual SD module cable to the connector on the
control panel board.
5
Close the system. See "Closing the System" on page 85.
6
Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
Processors
The system supports one-, two- and four-processor configurations. In one- or
two-processor configurations, processors are installed in sockets 1 and 2, and
FlexMem Bridges are installed in processor sockets 3 and 4 to enable the
processors to access the adjacent memory set. For more information on
installing a FlexMem Bridge, see "Installing a FlexMem Bridge" on page 141.
Table 3-5 provides a guide for one-, two-, and four-processor configurations.
Table 3-5. Processor Configurations
Configuration Processor Socket
1234
One-processor Processor and
heat sink
Plastic socket
cover
*
and heat-
sink blank
FlexMem
Bridge and heat-
sink blank
FlexMem
Bridge and heat-
sink blank
Two-processor Processor and
heat sink
Processor and
heat sink
FlexMem
Bridge and heat-
sink blank
FlexMem
Bridge and heat-
sink blank
Four-processor Processor and
heat sink
Processor and
heat sink
Processor and
heat sink
Processor and
heat sink
*Optional
book.book Page 133 Thursday, February 18, 2010 2:06 PM
To Next Page
Loading...
