Dell PowerEdge R810 - Page 157

Installing System Components 157
CAUTION: Do not lift the system board assembly by grasping a memory module,
processor, or other components.
20 Hold the processor board by the handle and a heat-sink release lever (see
Figure 3-23). Angle the processor board out toward the back of the system
and lift the board out of the chassis.
21 Pull the release pin and slide the I/O board forward and out of the chassis.
Figure 3-31. Removing and Installing the System Board
1 heat-sink release lever 2 power distribution board
3 release pin 4 I/O board
5 tab 6 high-speed connector
7 guide pins (2) 8 release levers (2)
9 processor board 10 handle
9
4
6
5
7
8
3
2
10
1
8
book.book Page 157 Thursday, February 18, 2010 2:06 PM