92 Installing System Components
7
If you are not adding a new optical drive, install the optical drive insert.
8
Close the system. See "Closing the System" on page 85.
9
Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
10
If applicable, install the front bezel. See "Installing the Front Bezel" on
page 83.
Figure 3-7. Removing and Installing the Optical Drive
1 power/data cable 2 release tab
3 optical drive
book.book Page 92 Thursday, February 18, 2010 2:06 PM
To Next Page
Loading...
