Dell PowerEdge R810 - Page 99

Installing System Components 99
Figure 3-10. Front-Chassis Assembly
To slide the front-chassis assembly back into the chassis:
1
Slide the assembly inside until the assembly snaps into position.
NOTE: For proper system cooling, make sure that the cables inside the system do
not obstruct airflow.
2 Route the SAS and SATA cables along the chassis wall and the RAID
battery carrier. See Figure 3-10.
1 front-chassis assembly 2 control panel cable
3 USB cable 4 SAS backplane power cable
5 cable clamp 6 RAID battery carrier
7 release tabs (2) 8 SATA cable
9 SAS cables (2)
7
1
2
3
4
8
5
6
9
book.book Page 99 Thursday, February 18, 2010 2:06 PM