Figure 84. Cabling diagram—2.5 inch (x8) SAS/SATA backplane
1.
signal connector on the backplane 2. cable retention bracket
3. SAS B connector on the PERC card 4. SAS A connector on the PERC card
5. system board 6. cable retention bracket
7. signal connector on the system board 8. SAS B connector on the backplane
9. hard drive backplane 10. SAS A connector on the backplane
Next steps
1. Replace the hard drive backplane.
2. Install the cooling fan assembly.
3. Install the cooling shroud.
4. Install all the hard drives.
5. Follow the procedure listed in the After working inside your system section.
142
To Next Page
Loading...
