Dell PowerEdge R830 - Page 146

Figure 88. Removing the vFlash connector/USB connector module
1.
vFlash connector/USB connector module 2. screw (2)
3. control panel connector cable
5. Locate and press the tabs on the information tag.
6. Push the information tag out of the slot to remove it from the control panel.
NOTE: Retain the information tag for replacement in the new control panel.
Figure 89. Removing the information tag
1.
information tag 2. tab
3. slot
Next steps
1. Replace the vFlash connector/USB connector module.
2. Replace the control panel.
3. Follow the procedure listed in the After working inside your system section.
146