Dell PowerEdge T610 - Entering the Idrac Configuration Utility

76 Using the System Setup Program and UEFI Boot Manager
• Enable a LAN Platform Event Trap (PET) destination
• Attach or detach the Virtual Media devices
• Change the administrative user name and password and manage user
privileges
• View System Event Log (SEL) messages or clear messages from the log
For additional information on using iDRAC6, see the documentation for
iDRAC6 and systems management applications.
Entering the iDRAC Configuration Utility
1 Turn on or restart your system.
2 Press < Ctrl><E > when prompted during POST.
If your operating system begins to load before you press <
Crtl><E >,
allow the system to finish booting, and then restart your system and try
again.
book.book Page 76 Tuesday, September 15, 2009 10:08 AM